Think seasons. I created this one in warm colors that work for autumn and winter. Why not make them for spring and summer too? You could use a floral fabric for the tree to create a summer rose topiary bush for example.
Sew a series of scrap stripes together. You do not have to cut them the same size. I would recommend you have a little wider stripe at the bottom to make it easier to add your stem.
For my trees, I made sure I had a width of 10 inches. Iron the seams flat and fold the stripes with right sides together.
Now be creative and cut out a shape of a tree freehand. No two trees are exactly alike as are our patchwork trees. With the wide bottom stripe, create a section of about an inch hanging down lower (see photo) for attaching your stem later. Insert a small length of cord (about 7 or 8 inches folded in half) at the top of the tree between the layers for your hanger.
If you would like to use a trim of any kind, be sure to pin this in place between the seams before you start to sew your tree together. Begin sewing on one side and work your way around. You will be turning the patchwork through the section that your stem is attached to.
Turn your piece and stuff. Stitch around the bottom opening with a running stitch which you will pull closed after the next step.
Use a branch about the width of your pinkie and cut it to about 4 inches. Glue the branch about 1 inch deep and along the top. Insert this into the little opening. You will need an extra pairs of hands for this step but while you hold the stem in place pull the running stitch to close the end against your stem. Tie a double knot and snip off the threads. My glue fastened immediately.
a - 2x 3-1/2 x 4 inch - roof
b - 4x 1 x 3-1/2 inch - house
c - 4x 1-1/4 x 1-1/2 inch - top windows front and back
d - 6x 1 x 1-1/2 inch - house beside windows
e - 1x 1-1/2 x 3 inch - front door
f - 1x 1-1/2 x 2 inch - front window
g - 1x 1 x 3 inch - house beside front door
h - 2x 3/4 x 2 inch - house beside front window
i - 1x 2 x 1-1/2 inch - house under front window
j - 3x 1 x 2 inch - house beside back windows
k - 2x 1-1/4 x 2 inch - back windowsl - 1x 3-1/2 x 1-1/2 inch - house
The diagram from below is from my newsletter and in Dutch but can be used to see the placement of all the pieces for sewing the patchwork. If you have any questions, please do not hesitate to ask.
In order to create the correct angle for the roof, fold the fabric in half to mark the middle point. Lay your ruler on the point to the lower outer corner and cut the fabric along this edge.
Front of house...